LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 829 (Suspension Control System - Suspension Damping) >> Repair Instructions >> Front Position Sensor Replacement-Electronic Suspension (15 series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the position sensor on the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolt to the frame.

    Tighten 

    Tighten the bolts to 12 N.m (106 lb in).

    Fig 1: Installing Position Sensor To Vehicle
    G01455664Courtesy of GENERAL MOTORS CORP.
  3. Install the ESC sensor link bracket bolt to the upper control arm.

    Tighten 

    Tighten the bolt to 9 N.m (80 lb in).

  4. Install the wheel speed sensor wire from the ESC sensor bracket.
  5. Install the wheel speed sensor wire to the ESC sensor bracket.
  6. Connect the sensor harness connector to the vehicle harness connector.
  7. Remove the safety stands.
  8. Lower the vehicle.
    Fig 2: Installing ESC Sensor Link Bracket Bolt To Upper Control Arm
    G01455665Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals