LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 826 (Front Suspension System) >> Repair Instructions >> Lower Ball Joint Replacement (Torsion Bar Suspension) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Use the outer flange of the ball joint in order to press the ball joint into place.

  1. Install the new ball joint using a press.
  2. Place the lower control arm in a bench vice.
  3. Using a punch, install crimps to the ball joint, if necessary. Use the replaced ball joint as a reference.
  4. Install the lower control arm. Refer to LOWER CONTROL ARM REPLACEMENT  .
  5. Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  6. Remove the safety stands.
  7. Lower the vehicle.
  8. Verify the wheel alignment. Refer to MEASURING WHEEL ALIGNMENT (WITH REAR WHEEL STEERING) or MEASURING WHEEL ALIGNMENT (WITHOUT REAR WHEEL STEERING) in Wheel Alignment under REPAIR INSTRUCTIONS .
scientia non olet · About LEMON Manuals