LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 819 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Recirculation Door Replacement (Visteon) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the recirculation door (1) to the recirculation housing (2).
    Fig 1: Installing Recirculation Door To Recirculation Housing
    G01454410Courtesy of GENERAL MOTORS CORP.
  2. Install the recirculation actuator (1) to the recirculation housing (2).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the screws to the recirculation actuator (1).

    Tighten: 

    Tighten the screws to 2 N.m (18 lb in).

  4. Connect the electrical connection to the recirculation actuator (1).
    Fig 2: Installing Recirculation Actuator To Recirculation Housing
    G01454411Courtesy of GENERAL MOTORS CORP.
  5. Install the upper recirculation housing (1) to the HVAC module assembly (2).
  6. Install the screws to the upper recirculation housing (1).

    Tighten: 

    Tighten the screws to 2 N.m (18 lb in).

  7. Install the wiring harness to the recirculation housing (1).
  8. Install the HVAC module assembly. Refer to HVAC MODULE ASSEMBLY REPLACEMENT  .
    Fig 3: Installing Upper Recirculation Housing To HVAC Module Assembly
    G01454412Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals