LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 818 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Rear (Avalanche/Escalade EXT) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat belt retractor.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the retractor bolt.

    Tighten 

    1. Tighten the retractor bolt to 53 N.m (39 lb ft).
  3. Route the seat belt through the pillar trim panel.
  4. Install the seat belt anchor bolt.

    Tighten 

    1. Tighten the seat belt anchor bolt to 53 N.m (39 lb ft).
  5. Install the third pillar trim panel. Refer to TRIM REPLACEMENT - THIRD PILLAR (TAHOE / YUKON / ESCALADE / SUBURBAN) or TRIM REPLACEMENT - THIRD PILLAR (AVALANCHE / ESCALADE EXT) in INTERIOR TRIM .
  6. Install the seat belt anchor cover.
  7. Install the rear removable glass panel.
  8. Install the rear floor door sill. Refer to DOOR SILL PLATE REPLACEMENT - REAR in INTERIOR TRIM .
  9. Set the rear seat up.
  10. Inspect the correct operation of the seat belt.
    Fig 1: Installing Retractor Bolt
    G01459720Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals