LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 818 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Left Front >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat belt retractor onto the seat. Line up the tab on the retractor to the tab on the seat frame.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the upper anchor bolt.

    Tighten 

    1. Tighten the bolt to 53 N.m (39 lb ft).
    Fig 1: Installing Upper Anchor Bolt
    G01459708Courtesy of GENERAL MOTORS CORP.
  3. Install the retractor tower cover.
  4. Install the retractor tower cover retaining screw.

    Tighten 

    1. Tighten the screw to 2 N.m (18 lb in).
    Fig 2: Installing Retractor Tower Cover
    G01459709Courtesy of GENERAL MOTORS CORP.
  5. Install the retractor.
  6. Install the retractor bolt.

    Tighten 

    1. Tighten the bolt to 53 N.m (39 lb ft).
  7. Install the rear cardboard panel retainers.
  8. Install the seat back cover and pad. Refer to SEAT BACK COVER AND PAD REPLACEMENT - FRONT in SEAT SYSTEM .
  9. Move the seat to its original position.
    Fig 3: Installing Retractor Bolt
    G01459710Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals