LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 817 (Seat System) >> Repair Instructions >> Seat Replacement - Rear No. 1 (60/40 Split) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat into the vehicle.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the seat retaining bolts.

    Tighten 

    1. Tighten the bolts to 55 N.m (41 lb ft).
  3. Connect the electrical connectors, if equipped.
  4. Install the jack assembly, if removed.
  5. Install the covers to the seat bolts.
  6. Install the seat back recliner handle screw, if removed.

    Tighten 

    1. Tighten the screw to 2 N.m (18 lb in).
  7. Install the front and the rear leg trim covers.
    Fig 1: Installing Seat Retaining Bolts
    G01459222Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals