LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 817 (Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear (Bench) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat cushion cover and pad to the seat frame.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts (1) on the roller assembly (2).

    Tighten 

    1. Tighten the bolts to 53 N.m (39 lb ft).
    Fig 1: Installing Bolts On Roller Assembly
    G01459236Courtesy of GENERAL MOTORS CORP.
  3. Install the support rod (1) to the bottom of the seat.
    Fig 2: Installing Support Rod To Bottom Of Seat
    G01459237Courtesy of GENERAL MOTORS CORP.
  4. Install the bolts (2) to the grab handle (1).

    Tighten 

    1. Tighten the bolts to 30 N.m (22 lb ft).
  5. Install the J-Clips on the back of the seat.
  6. Install the rear seat to the vehicle. Refer to SEAT REPLACEMENT - REAR NO. 2  .
    Fig 3: Installing Bolts To Grab Handle
    G01459238Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals