LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 817 (Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear (60/40 Split - 50/50 Split) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear passenger seat from the vehicle. Refer to SEAT REPLACEMENT - REAR NO. 1 (60/40 SPLIT)  or SEAT REPLACEMENT - REAR NO. 1 (BUCKET)  , SEAT REPLACEMENT - REAR NO. 2  or SEAT REPLACEMENT - REAR NO. 2 - 50-50  .
  2. Remove the rear passenger seat riser.
  3. Remove the seat cushion plastic cover from the seat cushion frame.
  4. Remove the hog rings and/or the J-clips from the rear edge of the seat cushion cover (3).
  5. Disconnect the rear heater connector, if equipped.
  6. Remove the seat belt buckles, if required. Refer to SEAT BELT BUCKLE REPLACEMENT - REAR or SEAT BELT BUCKLE REPLACEMENT - NO. 2 REAR (60/40 SPLIT - 50/50 SPLIT) or SEAT BELT BUCKLE REPLACEMENT - NO. 2 REAR (BENCH) in SEAT BELT SYSTEM s.
  7. Remove all of the remaining hog rings, and/or the J-clips that are retaining the seat cushion cover (3) to the seat cushion frame (8).
  8. Release the hook, and the loop-strips that are retaining the seat cushion cover to the foam pad (4).
  9. Remove the center screw retaining the latch cover.
  10. Remove the seat cushion cover from the foam pad.
    Fig 1: Removing Seat Cushion Cover And Pad - Rear
    G01459231Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals