LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 814 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (Utility) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the front and rear side doors.
  2. Remove the rear door. Refer to REAR DOOR REMOVAL/INSTALLATION in Doors.
  3. Pry with a suitable tool at the rocker panel molding section (2) to release tape.
    4. Fig 1: Removing Rocker Panel Molding (Utility)
    G01458459Courtesy of GENERAL MOTORS CORP.
  4. Pry at sections (4) to release spring clips from the rocker panel molding.
  5. Remove the rocker panel molding (3) from the vehicle.
scientia non olet · About LEMON Manuals