LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 814 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Door Body Side >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Important  : When any molding is removed, all retaining clips needs to be replaced with new ones if the molding is to be reused.

  1. Remove all retaining screws.
  2. Grasp the lower part of the molding.
  3. Pull outwards to release the clips from the body panel.
    4. Fig 1: Removing Front Door Body Side Molding
    G01458433Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals