LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 814 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Pickup Box >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the location of the emblem/nameplate has not been marked apply tape.
  2. Warm the pickup box surface with a heat gun J 25070  152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).

    Important  : Do not touch the adhesive backing of the emblem/nameplate.

    3. Fig 1: Installing Emblem/Nameplate - Pickup Box
    G01458410Courtesy of GENERAL MOTORS CORP.
  3. Remove the backing from the front end of the emblem/nameplate.
  4. Press the emblem/nameplate to the pickup box panel surface while continuing to remove the backing.
  5. Hand roll the emblem/nameplate to the pickup box panel to ensure proper adhesion.
  6. Inspect the emblem/nameplate for bonding.
  7. Remove the tape from the area around the pickup box emblem.
scientia non olet · About LEMON Manuals