LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 813 (Automatic Transmission - 4L80-E/4L85-E (Service & Replacement)) >> Repair Instructions >> Park Lock Pawl and Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Yukon XL, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pawl shaft.
  2. Install the parking pawl.
  3. Install the plug using a 8 mm or (5/16 inch) rod with Loctite® or equivalent.
  4. Install the retainer.
    Fig 1: Installing Park Lock Pawl And Actuator (1 Of 2)
    G02112244Courtesy of GENERAL MOTORS CORP.
  5. Install the pawl return spring.
  6. Install the detent lever to the actuator.
  7. Install the actuator over the parking pawl.
  8. Install the manual shaft seal.
  9. Lubricate the manual shaft with transmission oil and install the manual shaft into the case.
  10. Install the nut on the shaft.
  11. Install the roll pin.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  12. Install the parking lock bracket bolts.

    Tighten 

    Tighten the bolts to 24 N.m (18 lb ft).

  13. Install the PNP switch. Refer to PARK/NEUTRAL POSITION SWITCH REPLACEMENT  .
    Fig 2: Installing Park Lock Pawl And Actuator (2 Of 2)
    G02112245Courtesy of GENERAL MOTORS CORP.
  14. Install the transmission filter. Refer to AUTOMATIC TRANSMISSION FLUID/FILTER REPLACEMENT  .
  15. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to TRANSMISSION FLUID CHECKING PROCEDURE  .
scientia non olet · About LEMON Manuals