LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 812 (Automatic Transmission - 4L60-E/4L65-E (Service & Replacement)) >> Repair Instructions >> Transmission Extension Housing Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a drain pan under the vehicle.
  2. Remove the propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT -- REAR in Propeller Shaft.
  3. Remove the case extension housing rear oil seal. Use a flat bladed tool and carefully pry the seal from the housing.
  4. Inspect the case extension housing for damage. Replace the extension housing if necessary. Refer to TRANSMISSION EXTENSION HOUSING ASSEMBLY REPLACEMENT  .
    Fig 1: Removing Case Extension Housing Rear Oil Seal
    G02111860Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals