LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 812 (Automatic Transmission - 4L60-E/4L65-E (Service & Replacement)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission range selector cable bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the transmission range selector cable bracket bolts (1).

    Tighten 

    Tighten the bolts to 25 N.m (18 lb ft).

    Fig 1: Installing Bolts Securing Transmission Range Selector Cable Bracket
    G02111729Courtesy of GENERAL MOTORS CORP.
  3. Align and install the cable to the bracket.
  4. Install the retainer that secures the cable to the bracket.
  5. Lower the vehicle.
  6. Check the vehicle for proper operation. If cable adjustment is necessary, refer to Automatic Transmission Range Selector Cable Adjustment  .
    Fig 2: Installing Cable To Bracket
    G02111730Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals