LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Controls - Self-Diagnostics - 4.8L, 5.3L & 6.0L) >> Diagnostic Tests >> DTC P1134 & P1154: Ho2S Transition Time Ratio - Bank 1 & 2, Sensor 1 (6.0L W/Isolated Ground) >> Test Description

Test Description

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, and 2002 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers in the diagnostic procedures.

  1. 2

    After the HO2S heater is commanded ON, the HO2S heater heats up causing the HO2S signal voltage to either increase or decrease. This indicates that the HO2S heater is okay.
  2. 3

    If the HO2S voltage is varying outside the specified range, the condition is not present.
  3. 6

    If the test lamp illuminates, the low reference circuit between the HO2S and PCM terminal C1-63 is okay and the PCM low reference terminal is okay.
  4. 7

    If the voltage is below the specified value, the high signal circuit, the low reference circuit, and the PCM are okay.
  5. 11

    The opposite bank HO2S must be disconnected to isolate a short to ground in the HO2S heater high control circuit.
  6. 15

    Resistance within the specified range indicates the HO2S heater is okay.