Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Install the vent hose (1) to the clamp (2) on the filler hose (3).
- Route the same way as when removed.
- Ensure that the hose is free of kinks and is routed clear of sharp objects.
- Ensure that the vent is not plugged.
Fig 1: Installing Vent Hose To Clamp On Filler Hose
Courtesy of GENERAL MOTORS CORP.
Install the vent hose (1) in the clip (2) on the frame.

Fig 2: Installing Vent Hose In Clip On Frame
Courtesy of GENERAL MOTORS CORP.
Install the vent hose (1) to the top of the rear axle (2).
Remove the supports and lower the vehicle.

Fig 3: Installing Vent Hose To Top Of Rear Axle
Courtesy of GENERAL MOTORS CORP.