LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Body Rear End) >> Repair Instructions >> Latch Replacement - End Gate >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Engage the linkage rod to the latch assembly.
  2. Install the latch assembly to the vehicle.
    Fig 1: Engaging Linkage Rod To Latch Assembly
    G01459492Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the latch assembly bolts.

    Tighten 

    1. Tighten the bolts to 25 N.m (18 lb ft).
    4. Fig 2: Installing Latch Assembly Bolts
    G01459493Courtesy of GENERAL MOTORS CORP.
  4. Connect the cables on each side of the endgate to the side panel cable retainer bolts.
    5. Fig 3: Connecting Cables On Each Side Of Endgate To Side Panel Cable Retainer Bolts
    G01459494Courtesy of GENERAL MOTORS CORP.
  5. Engage the linkage rods (1).
  6. Raise the endgate.
    7. Fig 4: Engaging Linkage Rods
    G01459495Courtesy of GENERAL MOTORS CORP.
  7. Install the endgate handle bezel. Pressing into place until fully seated.
    8. Fig 5: Installing Endgate Handle Bezel
    G01459496Courtesy of GENERAL MOTORS CORP.
  8. Tighten the handle bolts.

    Tighten 

    1. Tighten the bolts to 25 N.m (18 lb ft).
      2. Fig 6: Installing Handle Bolts
      G01459497Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals