Disabling System (Expedition & Navigator)
WARNING: This page does not describe the selected car, but rather 114 other vehicles, including the 2000 Saturn SW2, 2000 Saturn SL2, 2000 Saturn SL1, 2000 Saturn SL, and 2000 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Wait at least one minute for backup power supply to deplete stored energy.
- Remove driver air bag module. See DRIVER AIR BAG MODULE . Connect appropriate air bag simulator to clockspring connector at top of steering column, in place of air bag. See AIR BAG SIMULATOR .
- Remove oval-shaped relay cover from passenger side of instrument panel. See Fig 1. Disconnect passenger side air bag module electrical connector. Connect appropriate air bag simulator to vehicle harness, in place of air bag. See AIR BAG SIMULATOR .
- If equipped with side air bags, disconnect side air bag electrical connectors under front seats. Connect appropriate air bag simulator to driver and passenger side air bag vehicle harness connectors, in place of air bag. See AIR BAG SIMULATOR . Connect negative battery cable.
WARNING:
If vehicle is equipped with side air bags, manufacturer recommends removing front seats (with side air bag modules) before performing electrical diagnosis on air bag system. Seats may be left in vehicle if diagnostics are NOT being performed on side air bag system and air bag simulator is installed in place of side air bag harness.