LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 795 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Bracket Replacement - Console Floor >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the console to the bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the fasteners retaining the console to the bracket.

    Tighten 

    Tighten the fasteners to 2 N.m (17 lb in).

  3. Install the vehicle sensor to the bracket. Refer to YAW RATE SENSOR/LATERAL ACCELEROMETER REPLACEMENT ANTILOCK BRAKE SYSTEM WITH TCVS & VSES
  4. Install the amplifier and bracket to the console bracket. Refer to AMPLIFIER REPLACEMENT in Entertainment.
  5. Install the console bin. Refer to CONSOLE STORAGE BIN REPLACEMENT (EXPECT PRO)  .
  6. Install the rear seat audio control to the console, if equipped.
  7. Install the console in the vehicle.
  8. Connect the wire connectors.
  9. Move the console forward in order to install the retaining screws.
    Fig 1: Installing Console Floor Bracket
    G01458196Courtesy of GENERAL MOTORS CORP.
  10. Install the 2 screws (1).

    Tighten 

    Tighten the screws to 4 N.m (35 lb in).

  11. Install the cupholder to the console. Refer to CUPHOLDER REPLACEMENT (NON-LUXURY)  or CUPHOLDER REPLACEMENT (LUXURY)  or CUPHOLDER REPLACEMENT (REAR)  .
  12. Install the upper console bezel. Refer to BEZEL REPLACEMENT - FLOOR CONSOLE (NON-LUXURY UPPER)  or BEZEL REPLACEMENT - FLOOR CONSOLE (LUXURY UPPER)  or BEZEL REPLACEMENT - FLOOR CONSOLE (NON-LUX LOWER)  .
  13. Install both front seats. Refer to SEAT REPLACEMENT - FRONT BUCKET in Seats.