LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 791 (Entertainment System) >> Repair Instructions >> Speaker Replacement - Rear Door >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the speaker mounting bracket.
  2. Install the bolts (2) retaining the speaker mounting bracket to the door, if removed.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

    Tighten 

    1. Tighten the bolts to 6 N.m (53 lb in).
    3. Fig 1: Installing Speaker Screws To Mounting Bracket
    G01457893Courtesy of GENERAL MOTORS CORP.
  3. Install the speaker to the mounting bracket.
  4. Connect the electrical connector to the speaker.
  5. Install the screws (1) that retain the speaker to the mounting bracket.

    Tighten 

    1. Tighten the screws to 2 N.m (53 lb in).
  6. Install the door trim panel. Refer to TRIM PANEL REPLACEMENT - SIDE REAR DOOR (TAHOE/YUKON/ESCALADE) or TRIM PANEL REPLACEMENT - SIDE REAR DOOR (SUBURBAN/YUKON XL/AVALANCHE/ESCLD EXT) in Doors.
  7. Verify the component operation.
scientia non olet · About LEMON Manuals