LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 785 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (Utility) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the front and rear side doors.
  2. Remove the rear door. Refer to DOOR REPLACEMENT - REAR .
    3. Fig 1: Rocker Panel Molding (Utility)
    GM869909Courtesy of GENERAL MOTORS CORP.
  3. Pry with a suitable tool at the rocker panel molding section (2) to release tape.
  4. Pry at sections (4) to release spring clips from the rocker panel molding.
  5. Remove the rocker panel molding (3) from the vehicle.
scientia non olet · About LEMON Manuals