LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 785 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Body Side - Lower Front (Avalanche) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Door Lower Molding (Tahoe/Yukon)
    GM741427Courtesy of GENERAL MOTORS CORP.
  1. Use a 3M™ Scotch Brite molding adhesive remover disc, P/N 07501, or equivalent, in order to remove any adhesive tape on the body panel.
  2. Remove the protective lining of the adhesive tape.
  3. Align the retaining clips in the respective holes.
  4. Press firmly on the molding until all of the retaining clips are completely seated.
  5. Press on the top part of the molding so that the tape adheres to the body panel.
scientia non olet · About LEMON Manuals