LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 785 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Door Lower (Tahoe/Yukon) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Door Lower Molding (Tahoe/Yukon)
    GM590177Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not scratch or chip the paint.
  1. Heat the bodyside molding using a heat gun. Hold the heat gun approximately 152 mm (6 in) from the surface.

    Apply heat using a circular motion for about 30 seconds.

  2. Starting from one end of the molding, remove the molding from the panel surface using a flat-bladed tool.
  3. Remove all of the adhesive from the body panel using a 3M™ Scotch Brite molding adhesive remover disc, P/N 07501, or equivalent.
scientia non olet · About LEMON Manuals