LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 784 (Power Steering System) >> Repair Instructions >> Pitman Shaft Seals and Bearing Replacement - Off Vehicle (670 Gear) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear pitman shaft and housing cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle (700 Gear)  or Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle (670 Gear)  .
  2. Remove the pitman arm (4) from the steering gear.
  3. Remove the pitman shaft boot (3) from the steering gear housing (1).
    Fig 1: Removing Pitman Arm & Shaft Boot
    G01662220Courtesy of GENERAL MOTORS CORP.

    Important:  Do not score the housing bore when prying out seals and washers.

  4. Remove the pitman shaft dust seal (2) from the steering gear housing (1).
  5. Remove the pitman shaft retaining ring (2) from the steering gear housing (1) using J 4245  .
    Fig 2: Removing Pitman Shaft Retaining Ring
    G01662221Courtesy of GENERAL MOTORS CORP.
  6. Remove the backup washer (3) from the steering gear housing (1).
  7. Pry the pitman shaft seal (2) from the steering gear housing (1) using a screwdriver.
  8. Inspect the housing for burrs and replace if necessary.
    Fig 3: Removing Backup Washer & Pitman Shaft Seal
    G01662222Courtesy of GENERAL MOTORS CORP.
  9. Insert J 6278  through the hole in the top of the steering gear housing (1).
  10. Drive out the needle bearing (2) from the steering gear housing (1).
    Fig 4: Driving Out Needle Bearing
    G01662223Courtesy of GENERAL MOTORS CORP.