LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Mechanical - 4.3L (Unit Repair)) >> Repair Instructions >> Crankshaft Rear Oil Seal and Housing Removal

Crankshaft Rear Oil Seal and Housing Removal

WARNING: This page is about a different car, the 2002 GMC Savana and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crankshaft rear oil seal from the crankshaft rear oil seal housing.

    Insert a suitable tool into the access notches and then carefully pry the crankshaft rear oil seal from the crankshaft rear oil seal housing.

  2. Discard the crankshaft rear oil seal.
    Fig 1: Crankshaft Rear Oil Seal
    G01689618Courtesy of GENERAL MOTORS CORP.
  3. Remove the crankshaft rear oil seal housing nut and bolts.
  4. Remove the crankshaft rear oil seal housing.
    Fig 2: Crankshaft Rear Oil Seal Housing, Nuts & Bolts
    G01689619Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft rear oil seal housing gasket.
  6. Discard the crankshaft rear oil seal housing gasket.
    Fig 3: Crankshaft Rear Oil Seal Housing Gasket
    G01689620Courtesy of GENERAL MOTORS CORP.
  7. Remove the crankshaft rear oil seal housing retainer stud from the engine block.
    Fig 4: Crankshaft Rear Oil Seal Housing Retainer Stud
    G01689621Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals