Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wiper motor on the vehicle.
- Install the 3 bolts. Tighten the 3 bolts to 7.0 N.m (62 lb in).
- Connect the wiper motor electrical connector.
Important: Assemble the wiper transmission to the crank arm past the second detent so that the seal is compressed to a maximum height of 25.5 mm (1.0 in).
Lubricate the inside of the socket with a lithium-based grease (GM P/N 1050109, 1052196 or equivalent).
- Connect the transmission drive link to the crank arm using the J 39529.
- Install the air inlet grille panel.
- Install the wiper arms.