LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 772 (Anti-Lock Brake System) >> Repair Instructions >> Wheel Speed Sensor Replacement (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the splash shield gasket.
  2. Install the wheel speed sensor splash shield (6).
  3. Install the 2 11 mm splash shield mounting bolts. Tighten the splash shield mounting bolts to 16 N.m (12 lb ft).
  4. Install the wheel speed sensor mounting bolts and nut. Tighten the speed sensor mounting bolts to 26 N.m (19 lb ft).
  5. Install the harness clips to the wheel speed sensor wire. Locate the clips at the paint dots on the wire.
  6. Install the harness clips with 3/16 inch rivets.
  7. Connect the wheel speed sensor electrical connector (2).
  8. Install the hub and rotor (3). Refer to FRONT BRAKE ROTOR .
  9. Install the brake caliper (1). Refer to FRONT BRAKE CALIPER .
  10. Install the tire and wheel.
scientia non olet · About LEMON Manuals