LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 770 (General Hydraulic Brake System) >> Repair Instructions >> Hydraulic Brake Booster Accumulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate all seals and metal friction points with power steering fluid.
  2. Install the accumulator (2) and O-ring seal (3).
  3. Place the J 26889  over the end of the accumulator.
  4. Install the nut on the stud.
  5. Depress the accumulator with a C-clamp.
  6. Install the accumulator retainer ring (2).
  7. Release the C-clamp.
  8. Remove the nut from the stud.
  9. Remove the J 26889  .
  10. Install the hydraulic booster. Refer to Hydraulic Brake Booster Replacement .
  11. Install the master cylinder to the hydraulic brake booster.
  12. Install the master cylinder nuts. Tighten the master cylinder nuts to 36 N.m (27 lb ft).
scientia non olet · About LEMON Manuals