LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 770 (General Hydraulic Brake System) >> Repair Instructions >> Brake Hose Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear brake hose (4).
  2. Install the junction block bolt (5). Tighten the junction block bolt to 17 N.m (13 Lb ft).
  3. Install the brake hose retaining clip (2).
  4. Connect the brake pipe fitting (9). Tighten the brake pipe fitting to 17 N.m (13 lb ft).
  5. Loosely connect the rear brake pipe fittings to the junction block. Using a backup wrench, tighten the rear brake pipe fittings to 17 N.m (13 lb ft).
  6. Ensure that the hose does not make contact with any part of the suspension. Check the hose in extreme right and extreme left turn conditions. If the hose makes contact, remove the hose and correct the condition.
  7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure)  .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals