LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 770 (General Hydraulic Brake System) >> Diagnostic Information & Procedures >> Braking Action Uneven - Pulls To One Side >> Test Description

Test Description

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refers to the step numbers on the diagnostic table:

  1. 2)  - Suspension components that are not operating properly may cause a disturbance to the vehicle during application of the brake system.
  2. 3)  - Steering components that are not operating properly may cause a disturbance to the vehicle during application of the brake system.
Braking Action Uneven - Pulls To One Side Diagnosis

Step Action Yes No
1 Were you sent here from the Hydraulic Brake Symptom Table? Go to Step 2  Go to Diagnostic Starting Point - Hydraulic Brakes 
2 Inspect the suspension system for proper operation. Refer to DIAGNOSTIC STARTING POINT - SUSPENSION GENERAL . Did you find and correct a condition? Go to Step 7  Go to Step 3 
3 Inspect the steering system for proper operation. Refer to DIAGNOSTIC STARTING POINT - POWER STEERING SYSTEM . Did you find and correct a condition? Go to Step 7  Go to Step 4 
4 Inspect the hydraulic brake system for proper operation. Refer to Hydraulic Brake System Diagnosis  Did you find and correct a condition? Go to Step 7  Go to Step 5 
5 Inspect the disc brake system for proper operation. Refer to Disc Brake System Diagnosis . Did you find and correct a condition? Go to Step 7  Go to Step 6 
6 Inspect the drum brake system for proper operation. Refer to Drum Brake System Diagnosis . Did you find and correct a condition? Go to Step 7  Go to Diagnostic Starting Point - Hydraulic Brakes 
7 Road test the vehicle in order to confirm proper operation. Refer to Brake System Vehicle Road Test  Is the condition still present? Go to Step 2  System OK