LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 768 (Wiring Systems (General Information)) >> Diagnostic Information & Procedures >> Push To Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

Fig 1: Push To Seat Connectors
G02505691Courtesy of GENERAL MOTORS CORP.
  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves (1).
  3. Use the proper pick or removal tool (1) in order to release the terminal.
    4. Fig 2: Releasing Terminal
    G02505692Courtesy of GENERAL MOTORS CORP.
  4. Gently pull the cable and the terminal (2) out of the back of the connector.
  5. Re-form the locking device if you are going to reuse the terminal (1).
    6. Fig 3: Re-Forming Locking Device
    G02505693Courtesy of GENERAL MOTORS CORP.
  6. To repair the terminal, refer to Terminal Repair  .
scientia non olet · About LEMON Manuals