Neutral Switch Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Remove the No. 1 engine mount rubber and No. 1 engine mount bracket.

Fig 1: No. 1 Engine Mount Rubber And Bracket
Courtesy of MAZDA MOTORS CORP.
Remove the neutral switch.
Install the neutral switch (with a new packing) to the transmission case.
1. Tightening torque 19.6-29.4 N.m {2.0-2.9 kgf.m, 14.5-21.6 ft.lbf}
Fig 2: Neutral Switch
Courtesy of MAZDA MOTORS CORP.
Install the No. 1 engine mount bracket and No. 1 engine mount rubber.

Fig 3: No. 1 Engine Mount Rubber And Bracket With Torque Specifications
Courtesy of MAZDA MOTORS CORP.