No. 4 Engine Mount Removal Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

To prevent crushing the front fender panel, insert a wood slab of appropriate size between the front fender panel and upper apron reinforcement.
NOTE:
- Wood slab height
  1. 4 door: approx. 35 mm
  2. 5 door: approx. 60 mm
- Cut the wood slab into two pieces and insert.
Fig 1: Inserting Wood Slabs Between Front Fender Panel And Upper Apron Reinforcement
Courtesy of MAZDA MOTORS CORP.
Support the engine using the SST.
NOTE:
- A hoist or small crane can be used in place of the SST (49E 017 5A0).
Remove the battery tray bracket, No. 4 engine mount rubber and bracket.

Fig 2: Supporting Engine Using SST
Courtesy of MAZDA MOTORS CORP.