Installation Procedure

Important:  Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.

1. Clean the area where the emblem/nameplate will be installed.

   Use a lint free cloth and Varnish Makers and Painters (VMP) naptha or a 50/50 mixture by volume of isopropyl alcohol and water to clean the area.

2. Dry the area thoroughly.
3. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
4. For the CHEVY BOW TIE emblem/nameplate install to the following dimensions:
   • The emblem/nameplate is centered from left to right on the rear compartment lid.
   • Dimension (A) is 192 mm (7.560 in) from the bottom of the rear compartment lid (1) to the emblem/nameplate.
     Fig 1: Identifying Chevy Bow Tie Emblem Proper Installation Position

     Courtesy of GENERAL MOTORS CORP.
5. For the V6 emblem/nameplate install to the following dimensions:
   • Dimension (a) is 20 mm (0.780 in) from the left edge of the rear compartment lid to the emblem/nameplate.
   • Dimension (b) is 27 mm (1.062 in) from the tail lamp (1) to the bottom of the emblem/nameplate.
     Fig 2: Identifying V6 Emblem/Nameplate Proper Installation Position

     Courtesy of GENERAL MOTORS CORP.
6. For the MALIBU LS emblem/nameplate install to the following dimensions:
   • Dimension (a) is 38 mm (1.500 in) from the left edge of the rear compartment lid to the emblem/nameplate.
   • Dimension (b) is 17 mm (0.670 in) between the MALIBU emblem/nameplate and the LS emblem/nameplate.
   • Dimension (c) is 29 mm (1.141 in) from the tail lamp (1) to the bottom of the emblem/nameplate.
   Fig 3: Identifying Malibu LS Emblem/Nameplate Proper Installation Position

   Courtesy of GENERAL MOTORS CORP.
7. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070  , if necessary.
8. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).

   Important:  Do not touch the adhesive backing on the emblem/nameplate.

9. Remove the protective liner from the back of the emblem/nameplate.
10. Position the emblem/nameplate to the location marks and press the emblem/nameplate to the mounting surface.
11. Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.
12. Remove the protective tape from the mounting surface.