Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
- Start the new stud into the axle flange hole by pressing firmly with your hand.
- Install a washer and thread the lug nut on the wheel stud with the flat side of the lug nut to the vehicle.
- Tighten the lug nut in order to draw the wheel stud into the rear of the flange.
- Remove the lug nut and washers from the wheel stud.
- Install the brake drum.
- Install the tire and the wheel.
- Lower the vehicle.