LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 734 (Front Suspension System) >> Repair Instructions >> Upper Control Arm Bushings Replacement (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm shaft into the upper control arm.
  2. Install the upper control arm bushings into the upper control arm. Use the J 22269-01  and a short piece of pipe that is the same outer diameter as the rubber bushing.
  3. Tighten the J 22269-01  until the bushing is positioned on the shaft and the control arm as shown. The measurement should be 12.8-13.8 mm (0.48-0.52 in) on both ends.
  4. Install the upper control arm shaft retainers and the retaining nuts. Tighten the upper control arm shaft retaining nuts to 115 N.m (85 lb ft).
  5. Install the upper control arm to the vehicle. Refer to Upper Control Arm Replacement (RWD)  or Upper Control Arm Replacement (AWD)  .
scientia non olet · About LEMON Manuals