LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 734 (Front Suspension System) >> Repair Instructions >> Shock Absorber Replacement (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock absorber, fully extended, up through the hole in the lower control arm.
    • The lower retainer and the insulator must be attached to the shock absorber upper stem before positioning the shock absorber.
    • The shock absorber upper stem will pass through the mounting hole in the upper control arm frame bracket.
  2. Install the upper insulator, the retainer, and the shock absorber mounting nut over the shock absorber upper stem.
  3. Install the shock absorber mounting screws through the holes in the lower control arm.
    1. 3.1. Make sure the nuts are aligned properly.
    2. 3.2. Tighten the shock absorber mounting nut to 20 N.m (15 lb ft), while holding the upper stem of the shock absorber.
    3. 3.3. Tighten the shock absorber mounting screws to 25 N.m (18 lb ft).
  4. Install the tire and wheel.
  5. Lower the vehicle.
  6. Dispose of the shock absorber. Refer to Shock Absorber Disposal .
scientia non olet · About LEMON Manuals