LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 731 (Steering Wheel & Steering Column) >> Repair Instructions >> Tilt Spring - Assemble - Off Vehicle

Tilt Spring - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the tilt spring (2) with synthetic grease.
  2. Fig 1: Lubricating Tilt Spring With Synthetic Grease
    G02501507Courtesy of GENERAL MOTORS CORP.
  3. Install the spring guide (1) into the tilt spring (2).
    CAUTION: The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily Injury may result during removal and Installation of the tilt spring and the spring guide. Always use caution during removal and Installation of the tilt spring and the spring guide.
  4. Install the tilt spring (1).
    1. Install the tilt spring (1) to the post on the steering column support assembly (2).
    2. Secure the tilt spring (1) with locking pliers.
  5. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle  .
  6. Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .