Steering Column Tilt Head Housing - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 23653-SIR Steering Column Lock Plate Compressor
J 42137 Steering Column Lock Plate Compressor Adapter

Install the following parts onto the steering shaft assembly:
1. The inner race (4)
2. The upper bearing inner race seat (3)
3. The upper bearing spring (2)
4. Lubricate the turn signal cancel cam assembly (1)
5. The turn signal cancel cam assembly (1)
Fig 1: Identifying Steering Shaft Assembly Components
Courtesy of GENERAL MOTORS CORP.
Install the shaft lock shield assembly (1) onto the steering shaft assembly.

Fig 2: Identifying Shaft Lock Shield Assembly
Courtesy of GENERAL MOTORS CORP.
Install the bearing retainer using J 23653-SIR and J 42137 .
Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle .
Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .