LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 731 (Steering Wheel & Steering Column) >> Repair Instructions >> Linear Shift Assembly - Assemble - Off Vehicle

Linear Shift Assembly - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. If installing the linear shift assembly as an assembly, proceed to step  12 . Install the shift lever gate (3) onto the gear shift lever assembly support bracket (1).
  2. Install the 3 oval head screws (2) onto the shift lever gate (3). Tighten the 3 oval head screws to 7 N.m (62 lb in).
  3. Install the 2 actuator bushings.
  4. Install the shift actuator shaft.
  5. Install the cable shift cam assembly (3).
  6. Install the ball and actuator assembly (1).
  7. Install the 2 hexagon flange head bolts (2). Tighten the 2 hexagon flange head bolts to 18 N.m (13 lb ft).
  8. Install the automatic transmission shift lock control.
  9. Install the shift lever clevis and put the column in the neutral position. This will be 2 positions from the park position.
  10. Slide the park position switch assembly onto the linear shift assembly.
  11. Connect the automatic transmission shift lock control connector onto the park position switch assembly.
  12. Install the linear shift assembly onto the steering column support assembly.
  13. Secure the linear shift assembly to the steering column assembly with the 3 flat head tapping screws. Move the linear shift assembly out of the PARK position to install the lower socket tapping screw. Tighten the 3 TORX(tm) screws to 10 N.m (89 lb in).
  14. Connect the park lock cable assembly (1) to the lock module assembly in the following way:
    • Place the steering column lock cylinder set into the off position.
    • Place the shift lever clevis into the park position.
    • Press the locking tab on the end of the park lock cable assembly (1) into the slot in the lock module assembly.
  15. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle  .
  16. Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals