LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 731 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Switch Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slide the ignition and key alarm switch assembly (2) into the lock module assembly (1).
  2. Install the key alarm connector (1) into the lock module assembly (2).
    1. Push the key alarm connector (1) into the lock module assembly (2).
    2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
    3. Install the passkey connector into the lock module assembly (2).
  3. Connect the multifunction switch electrical connectors to the bulkhead connector (1).
  4. Install the wire harness assembly (1) to the wire harness strap (2).
  5. Attach new wire harness straps to the wire harness assembly (1).
  6. Connect the steering column electrical connectors to the vehicle.
  7. Install the trim covers to the column. Refer to Steering Column Trim Covers Replacement - On Vehicle  .
  8. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals