LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 731 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Lock Cylinder Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari and 2002 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert the ignition lock cylinder through the upper shroud.
  2. Install the ignition lock cylinder to the lock module by doing the following:
    1. Align the positioning slot and locking tab slot on the lock module assembly to the positioning tab and locking tab on the ignition lock cylinder.
    2. Push the ignition lock cylinder into the lock module assembly until the locking tab locks against the lock module.
  3. Install the upper steering column trim cover mounting screws. Tighten the upper steering column trim cover mounting screws to 1.5 N.m (31 lb in).
  4. Install the lower steering column trim cover. Refer to Steering Column Trim Covers Replacement - On Vehicle  .
  5. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  6. Connect the battery negative cable.
  7. Perform the Passlock learn procedure. Refer to PROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS .
scientia non olet · About LEMON Manuals