Test Description
WARNING: This page is about a different car, the 2002 GMC Cab & Chassis Sierra and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
The numbers listed below refer to step numbers in the diagnostic procedure:
- 4
This step tests for stoplamp switch voltage to the PCM connector. - 7
This step isolates the stoplamp switch as a source for setting the DTC. - 10
This step tests for a short to ground in the ignition voltage circuit (441) to the stoplamp switch. - 12
This step tests for a short to ground in the brake switch signal circuit (420), from the stoplamp switch to the PCM. - 13
This step isolates the PCM as a source for causing the fuse to open.