Installation Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Position the latch assembly (3) to the alignment marks on the rear compartment lid.CAUTION: Refer to FASTENER NOTICE .
- Install the rear compartment lid latch bolts (7) to the rear compartment lid.
Tighten
Tighten the bolts to 11 N.m (97 lb in).
- Install the remote release cable (1) to the lock release box, if equipped.
- Connect the electrical connector to the rear compartment lid latch, if equipped.
- Press the rear compartment lid latch cable (8) onto the lock cylinder until the retainer tabs are fully seated.
- Close the rear compartment.