LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 716 (Manual Transmission - ZF S6-650) >> Repair Instructions >> Transmission Input Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the NEW seal in the front case with the part number facing out.
  2. Using J 44731 install the input shaft seal.
  3. Position the clutch actuator cylinder.
  4. Install the clutch actuator cylinder bolts. Tighten the clutch actuator cylinder bolts to 8 N.m (71 lb in).
  5. Install the transmission. Refer to Transmission Replacement .
  6. Install the rear propeller shaft.
  7. Check the transmission fluid level. Add if necessary.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals