LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 715 (Manual Transmission - NV 4500) >> Repair Instructions >> Transmission Housing Rear Oil Seal Replacement (2WD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using J 22834-A  install the NEW rear oil seal.
  2. If required, install the following:
    1. 2.1. The yoke
    2. 2.2. A NEW main shaft washer
    3. 2.3. A NEW prop shaft yoke washer
    4. 2.4. The main shaft nut
  3. If required, use J 8614-01  in order to keep the keep yoke from rotating.
  4. Tighten the main shaft nut. Tighten the main shaft nut to 441 N.m (325 lb ft).
  5. Install the rear propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - ONE PIECE or PROPELLER SHAFT REPLACEMENT - TWO PIECE .
  6. Check the transmission fluid level. Add if necessary.
  7. Lower the vehicle.