LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Engine Mechanical - 3.1L (On-Vehicle)) >> Repair Instructions >> Engine Oil Level Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the oil level sensor to the oil pan with the retainer bolt.

    Tighten 

    Tighten the bolt to 16 N.m (12 lb ft).

  2. Connect the electrical connector to the oil level sensor.
  3. Lower the vehicle.
  4. Add oil to the proper level.
    Fig 1: Installing Engine Oil Level Sensor
    G01810959Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals