Rear Brake Caliper: Removal
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 1999 Pontiac Montana, 1999 Oldsmobile Silhouette, 1999 Oldsmobile Bravada, 1999 GMC Yukon, and 1999 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
- Remove 2/3 of brake fluid from master cylinder. Raise and support vehicle. Remove wheel. Using "C" clamp or large pliers, compress caliper piston until it bottoms in its bore.
- Disconnect brake hose from caliper. Remove caliper support key bolt. See Figure or Figure . Drive out caliper support key and spring. Remove caliper. Remove inner and outer pads.