Removal Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Disable the SIR system. Refer to DISABLING SYSTEM .
- Remove the defroster grille. Refer to Defroster Grille Replacement .
- Remove the outer trim covers. Refer to Instrument Panel (IP) Outer Trim Cover Replacement .
- Remove the instrument panel (IP) compartment. Refer to Compartment Replacement - IP .
- Remove the passenger side SIR inflator module. Refer to AIR BAG MODULES .
- Remove the left front and right front sound insulators. Refer to Closeout/Insulator Panel Replacement - Right and Closeout/Insulator Panel Replacement - Left .
- Remove the steering wheel. Refer to STEERING WHEEL .
- Remove the multifunction switch. Refer to MULTIFUNCTION TURN SIGNAL SWITCH .
- Remove the IP cluster trim plate. Refer to Trim Panel Replacement - IP Cluster .
- Remove the IP accessory trim plate. Refer to Trim Plate Replacement - IP Accessory .
- Remove the IP cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
- Remove the HVAC controls. Refer to HVAC MODULE ASSEMBLY .
- Remove the radio and the remote cassette player. Refer to RADIO REPLACEMENT and REMOTE CASSETTE PLAYER REPLACEMENT .
- Remove the ignition switch bolts. Refer to Ignition Switch Replacement .
- Disconnect the outboard electrical connectors from the IP wiring harness junction blocks.
- Remove the center console. Pull the console rearward in order to disengage the console from the instrument panel. Refer to Console Replacement .
- Remove the ashtray from the IP carrier.
- Remove the screws (2, 3, 4) connecting the IP carrier (1) to the cross vehicle beam (6).
- Remove the IP carrier (1) from the cross vehicle beam (6).