LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 694 (Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bucket seat. Refer to Seat Replacement .
  2. Remove the seat cushion cover and the cushion as one piece. Refer to Seat Cushion Cover Replacement - Front .
  3. Remove the seat adjuster bolts from the seat cushion frame.
  4. Remove the electrical wire harness from the seat cushion frame if required.
    Fig 1: Identifying Seat Cushion Frame
    G01780558Courtesy of GENERAL MOTORS CORP.
  5. Remove the seat adjuster from the seat cushion frame.
  6. Remove the seat belt buckle bolt. Remove the seat belt buckle.
    Fig 2: Removing Seat Adjuster
    G01780559Courtesy of GENERAL MOTORS CORP.
  7. For the 6-way adjuster remove the motor support bracket. Refer to Seat Adjuster Motor Replacement - Front .
  8. For the 2-way or 4-way adjuster, perform the following steps if required:
    1. 8.1. Remove the seat adjuster return springs (1, 3).
  9. 8.2. Remove the seat adjuster linkage wire (4).
  10. 8.3. Drill out the rivet (5) for the electrical wire harness bracket.

    Remove the bracket from the seat adjuster.

  11. 8.4. Remove the seat adjuster 2-way handle retaining clip, if equipped.

    Remove the 2-way handle from the seat adjusters.

  12. 8.5. Disconnect the electrical wire harness (2) from the adjuster motor, if equipped.
    Fig 3: Removing 2-Way Or 4-Way Seat Adjuster
    G01780560Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals